People over 30 to 40 will always realize that facial skin start loosening and sagging which is why they wish the skin could be tighter and youthful. There are various tightening techniques used, with other methods involving surgery. Objective comparison of well performed face lifts with non-surgical treatment reveal that best treatments will only achieve 20 to 30 percent of standard face lift result. When considering skin tightening Portland residents should know what is involved.
There are recent procedures that are more invasive and sub-cutaneous that are known to achieve better results than techniques used presently. As a matter of fact, newer laser technologies continue to improve and replace older technologies using radio-frequency or infrared tightening. As you consider opting for treatment, one should know the way in which the procedure works.
As one gets older, the skin loses its elasticity. It is elasticity that holds skins tightly to the face and body. The components elastin and collagen are what elasticity depends on. They are found in the dermis. They are responsible for tightness and are usually in the deepest parts of skins, some distance above the fat layer that lies beneath. When collagen gets heated to 66 degrees, it contracts and skin gets tightened. This is known as remodeling and will take place some months after collagen is heated.
In all techniques that are used, the main aim is heating collagen to make it contract and tighten skin as a result. In order to achieve tightening, either infra-red energy or radio frequency or a combination of the two will be used. The machines used do have cooling devices that are complicated and which cool the surface such that burns will be prevented as heat is transmitted into the dermis.
It is important to be prepared for the treatment. Some 3 to 4 weeks prior to treatment, one will be advised to apply sun block and keep off direct sunlight. For those that are undergoing tretinoin treatment, it should be stopped at least one week in advance. People predisposed to conditions like oral herpes will have to be prescribed for oral antivirals. This should be applied daily before and after treatment is concluded.
The treatment normally lasts between 30 minutes to an hour but can go for longer depending on an individual and areas being treated. Places like the neck and face take longer. The eyes should be covered so that they are protected. In general, some warmth can be felt during treatment and anesthesia is hardly ever needed.
The infra-red pulses are directed to required areas of the face and body. The lasers emit energy which are absorbed by water within the skin. This will affect collagen and finally contract which is what leads to tightening. There might be redness and warmth after treatment that diminishes within a couple of hours. Results can be realized between 90 and 180 days following treatment. This is the time required ti form new collagen.
Some of the expected complications are redness and swelling. On rare occasions, bruises and blistering can occur. If the side effects are serious, the doctor should be informed immediately.
There are recent procedures that are more invasive and sub-cutaneous that are known to achieve better results than techniques used presently. As a matter of fact, newer laser technologies continue to improve and replace older technologies using radio-frequency or infrared tightening. As you consider opting for treatment, one should know the way in which the procedure works.
As one gets older, the skin loses its elasticity. It is elasticity that holds skins tightly to the face and body. The components elastin and collagen are what elasticity depends on. They are found in the dermis. They are responsible for tightness and are usually in the deepest parts of skins, some distance above the fat layer that lies beneath. When collagen gets heated to 66 degrees, it contracts and skin gets tightened. This is known as remodeling and will take place some months after collagen is heated.
In all techniques that are used, the main aim is heating collagen to make it contract and tighten skin as a result. In order to achieve tightening, either infra-red energy or radio frequency or a combination of the two will be used. The machines used do have cooling devices that are complicated and which cool the surface such that burns will be prevented as heat is transmitted into the dermis.
It is important to be prepared for the treatment. Some 3 to 4 weeks prior to treatment, one will be advised to apply sun block and keep off direct sunlight. For those that are undergoing tretinoin treatment, it should be stopped at least one week in advance. People predisposed to conditions like oral herpes will have to be prescribed for oral antivirals. This should be applied daily before and after treatment is concluded.
The treatment normally lasts between 30 minutes to an hour but can go for longer depending on an individual and areas being treated. Places like the neck and face take longer. The eyes should be covered so that they are protected. In general, some warmth can be felt during treatment and anesthesia is hardly ever needed.
The infra-red pulses are directed to required areas of the face and body. The lasers emit energy which are absorbed by water within the skin. This will affect collagen and finally contract which is what leads to tightening. There might be redness and warmth after treatment that diminishes within a couple of hours. Results can be realized between 90 and 180 days following treatment. This is the time required ti form new collagen.
Some of the expected complications are redness and swelling. On rare occasions, bruises and blistering can occur. If the side effects are serious, the doctor should be informed immediately.
About the Author:
Find complete details about different skin tightening Portland treatment options and more info about a reputable esthetician at http://myaestheticlaser.com right now.
Aucun commentaire:
Enregistrer un commentaire